3 hr on materials organizing, 2.5 hours on SEH carport

6 on house, 1 on materials storage

Not quite finished carport.

Carport wall panels & batons

Continuing work on Carport. Installing wall panels and batons.

Work on Seed Eco-Home2 - pebble skirt installed.

Workshop - CNC Torch table - Z Babystepping Multiplicator adjusted from 1 to 10. Note Babbystepping only works when nozzle is in motion. If nozzle is stationary, i.e. during delay or waiting - turning controller knob for babbysteping nozzle only moves down whichever way knob is turned.

raking around SEH2 for pebble skirt

1 hour work on Seed Eco-home 2

Work on CNC torch table nozzle speed experiment temporarily aborted due to inability to adjust Z height effectively during cut.

Experimentation of nozzle speeds with 4mm Z height

Continuing experimentation with 3mm and 4mm Z height. 3mm height caused slag splashing and flamed out. Choosing to proceed with 4mm Z height. Next carry out nozzle speed tests.

Continuing to achieve experiment repeatability

Set acetylene pressure to 2psi.

Fixed Z probe perpendicular to cut surface. Continuing Z height experiments.

Attempt to cut blade 5 failed miserably. Step back to reevaluate parameters for perfect cut. Z height experiments.

Blades 3 & 4

Blades 1 & 2 cut

Inspection By DoL.

Calibration of CNC Torch Table continued and workshop tidy up ready for inspection on Wednesday 17th Nov. 2021 by DoL. Jon Miller also on site.